в соответствии с

. в зависимости от; изменяться в соответствии с кривой; классификация по; находиться в соответствии с; согласно; соответствие

•

In line with this assumption, we have devised a model of ...

•

To modify the beach profile in response to changing wave conditions ...

•

Evaporators for marine use are classed as horizontal or vertical by (or according to, or depending on) the position of their tubes.

•

The test report is performed in accord(ance) (or conformity, or compliance) with the specifications.

•

In keeping with the limitation of only four orbitals, the formation of double or triple bonds between atoms of these elements reduces the coordination number of the central atom.

•

The machine is designed and built to higher standards of accuracy.

•

The sketch can be interpreted in terms of either system.

•

The console pressure can be regulated to match the individual gauge range.

•

In the reactors designed around this approach the energy-carrying neutrons released by thermonuclear reactions will be absorbed in a lithium blanket.

•

These techniques must be selected in relation to the properties of the substances being separated.

* * *

В соответствии с (нормами)

 The specimens were tested at a frequency of approximately 130 Hz, following ASTM E466 [...].

В соответствии с -- in accordance with, in agreement with, in keeping with, in line with, in compliance with, consistent with; as required by, to match, following, according to; in step with (синхронно); per (в инструкциях); to conform to (о требованиях стандарта и т. п.), pursuant to (в письмах)

 Fatigue life results of the bearings tested were statistically analyzed in accordance with the methods of [...].

 In agreement with this, it was found that the low ф machine went into a part-span stall.

 Also, in keeping with practice, the inter-plate spacing was made equal to the plate length.

 The section on low-pressure heating boilers now had testing and marking requirements in line with those of the power boiler section.

 (Tf -- Ts) is kept fixed by increasing Ts with time as required by the surface temperature, Ts.

 Normally, this value of radial clearance is established to match the bearing size.

 According to a previous investigation of dressing [...], fracture can occur within the grain.

 The Sh number increases in step with the wake turbulence.

 Install housing and grease per figure and table.

 They are metered by orifice plate assemblies built to conform to BS 1042.

 Pursuant to your request, I am confirming our consent to the publication of the book in two volumes.

 Floating roof tanks generally do not require protection when installed in compliance with Section ...